Sykes & co. Brass backed

Discussion in 'Forum: Saw Identification and Discussion' started by Lostarrow, Aug 7, 2021.

  1. Lostarrow

    Lostarrow Active Member

    Messages:
    26
    A little gem that I look forward to putting back to use . The brass back was polished up by a previous owner but the rest looks pretty much untouched ( other than the replacement iron bolt )
    Any input on age or history is always greatly appreciated .
     

    Attached Files:

  2. shoarthing

    shoarthing Most Valued Member

    Messages:
    111
    As I have no doubt you have already seen, you saw’s stamp has some similarities to another recent-ish find by Gareth

    Great pity the rearward flat saw-screw has been replaced (quite neatly) with a m/s rivet made from what looks like a 6” round nail
     
  3. Lostarrow

    Lostarrow Active Member

    Messages:
    26
    I haven’t attempted to remove ( and won’t ) the iron bit , but I believe it’s threaded as the split nut is on the other side holding it in . I could be wrong .
    It is sort of a pity , but then again , it also tells a story like the scars we carry from our adventures .
     
    Last edited: Aug 7, 2021