Here another nice old rip saw, made by Moulson Bros. 26" 6ppi, no pitting but does have one tooth missing, this doesn't affect the performance. The stamped in makers mark is very clear and has, double refined, in the lower cresent. I used to brand my name into the handle when they went into my tool box, but I've stopped doing this now.
Hi Lui, I love those big old rip saws, and it's good to see them being looked after and used as they were intended. Moulsen Brothers, (referring to Simon's research), were in business from 1828 to 1893. Trying to identify the features might provide a clue as to date. Judging by the unevenness in the mark, I suspect that it is stamped rather than etched, and so might be pre 1850. 4 screws, Recessed label screw (medallion). "Double Refined" might be a clue.. I would have expected to see "Warranted Cast Steel" ?? Straight back, square heel... Nicely defined lambs tongue, beautifully shaped handle (I bet it's a delight to hold and use) Sorry Lui, I'm unsure.... I think maybe pre 1850, but I'd like more opinions on when "Double Refined" was used. Regards Ray PS Regards Stamping your name on saws, I think if you are using them as a craftsman, you are entitled to stamp you name on them, it then becomes part of the history. Nothing I like more than a saw with 2 or 3 owners marks, reminds me of all those who have owned, used and looked after the saw over the years.
Hi Lui, Just looking again at that saw. What is the rake angle on the front of the teeth? Going by the pictures it looks like 15 degrees or so, which seems a bit relaxed for a rip saw. But then, I can't see any fleam, so it must be filed straight across (as in rip). Just curious. That missing tooth will "grow" back nicely after a few jointing and sharpenings. Generally a missing tooth isn't a problem. Regards Ray