First off going to have to disappoint regarding picture at this stage but hope to later. Many thanks for the prompt replies and my apologies for...
Hi folks, hoping you might be able to help me on this one please. This saw has a steel back and very small lettering on the lowest possible edge...
Cheers Joe, yes, had seen that thread thanks. Will let Simon have a close look at it next week at Stanleys sale. The "nip" as I call it is the...
I happened to get this saw for just £1 from one of those wonderful Norfolk Saturday Car Boots a few weeks back. Very nearly did not buy it owing...
Looking forward to getting mine from Simon at the Stanley sale. Not long now.......
The all important sizes..... 32 1/2" long 9 1/4" o/a heel 15" of steel along back to cut slope 2" toe 20" from heel to trade mark It was...
Yes Joe it is still mine and sorry I should have given you a reference measurement. Just need to find it now!! Good point about the 5...
This saw sat neglected under a stall at Saddington boot sale for years until one morning I paid it more attention. The secondary slope of the...
Great stuff Simon , I thought it looked a bit special. Etching this sort of intricate design just blows me away and I take my hat off to those...
Well after not being on here for a long time I thought you might like to see this un-drilled and ornately etched plate for a MARSHES & SHEPHERD...
Separate names with a comma.