W. Hoole mark
Kiwi, I have found the same to be true on the two early Kenyon handsaws I measured. One is stamped Kenyon and the other Kenyon & Co. if I...
This is a saw I recently acquired made by an unknown Browne (unknown to me at least). The stamp reads BROWNE C__T _____ REFD I think it...
Fred, I realize this thread is quite old but I thought I would post some pics of a saw I recently acquired that might be of interest to you. The...
I’ve been stretched a bit thin lately and should’ve posted this when it arrived. 15” Barnet & Son hand saw (the toe has broken off and I’m...
Here is my 8” GEO • BLAKE[ATTACH] [ATTACH] [ATTACH]
Thank you for explaining it to me. My one piece saw worked fine but was only used a couple of times before I trashed it. I got a little too...
Matt, the saw looks good but wouldn’t it just be easier to use a friction fit. A friction fit, if done correctly, accomplishes the same thing as a...
Great saw Scott! I’m actually in the process of making one that will look very similar.
nice job. I think I’ve already told you this elsewhere though....
Matthew, Blackburn has a blog section where Isaac lays out the process for making a saw start to finish. The depth in his backs are 5/16”, I...
Thank you David.
I recently purchased a 14” backsaw on an auction site that is stamped John Peck & Co. Liverpool. The importance to me lies with the name Peck....
Thank you Ray. I picked up this saw before I had received my copy of BSSM and remember finding some posts by you regarding the Marsden family....
Before I start this post I would like to thank Ray for helping me get registered and confirmed. I have been lurking in the background but...
Separate names with a comma.