| Most viewed - ray's Gallery |
Drill Press Setup778 viewsThe drill press table is squared up carefully and the height adjusted to exactly the height required, the brass is fed slowly, with frequent stopping to check the cut is tracking, and to let the brass cool down enough to be handled.
|
|
Lie Nielson754 viewsOpen Handle Template for Lie Nielson
Wood :- Curly Maple
|
|
Test fitting695 viewsTesting the fit using a piece of 1095 0.020" spring steel plate.
|
|
End view of slitting691 viewsNot the build up of swarf that needs frequent stopping to keep clear, it is important not to let the swarf accumulate under the workpiece.
|
|
Overview of drill press setup647 viewsShowing clamps holding the fence and support block.
|
|
Cutting out the Blank641 viewsHacksaw out the blank, and clean up on a linisher, disk sander or file the edges square
|
|
Disston No 4625 viewsHandle Template for Disston No4
|
|
Spear and Jackson No. 26 12" Carcass Saw611 viewsSpear and Jackson No. 26 12" Carcass Saw
|
|
Disston No 77608 viewsHandle Template for Disston No 77 Tenon Saw
|
|
Shop Made588 viewsOpen Handle Template for Shop Made Saw (Ray Gardiner) This one is tweaked to suit me.
Wood: Figured Walnut
|
|
Melvin (Taylor Brothers) London Pattern576 viewsHandle Template for Melvin London Pattern
|
|
Taylor Brothers576 viewsTaylor Brothers Dovetail Saw 10"
|
|
| 119 files on 10 page(s) |
 |
1 | |
|
|
|
|
|
|
|
|
|
